Table of Contents
Advertisement
SDM-300L3 Satellite Modem
Remote Control Operation
Bulk Consol.
Status
(continued)
Parameter
Number
17
18
19
20
21
22
23
24
25
26
27
28
(Note 16)
29
30
31
32
33
34
Parameter Name
(Command Reference)
Demodulator rate
(ref. 'DR_' command).
Demodulator preset A
(ref. 'ADRA_' command).
Demodulator preset B assignment
(ref. 'ADRB_' command).
Demodulator preset C assignment
(ref. 'ADRC_' command).
Demodulator preset D assignment
(ref. 'ADRD_' command).
Demodulator preset V assignment
(ref. 'ADRV_' command).
Descrambler enable
(ref. 'DE_' command).
Differential decoder
(ref. 'DDEC_' command).
Reserved null field
IF Loopback
(ref. 'IFL_' command).
Sweep center frequency
(ref. 'SCF_' command).
Sweep width range
(ref. 'SWR_' command).
Sweep reacquisition
(ref. 'SR_' command).
BER threshold
(ref. 'BERT_' command).
Demodulator type
(ref. 'DT_' command).
Demodulator decoder type
(ref. 'DDT_' command).
Transmit clock source
(ref. 'TC_' command).
External reference frequency
(ref. 'ERF_' command).
Description
p17 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p18 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p19 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p20 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p21 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p22 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p23 = n, where 'n' is '0' (off) or '1' (on).
p24 = n, where 'n' is '0' (off) or '1' (on).
P26 = n, where 'n' is '0' (off) or '1' (on).
p27 = snnnnn, sweep center frequency in Hertz.
p28 = nnnnnn, sweep range in Hertz.
p29 = nnn, reacquisition time in seconds.
p30 = xxxx, BER threshold.
p31 = n, where 'n' is '0' (EFD), '1' (INTL), '3' (FDC), or '4'
(CSC).
p32 = n, where 'n' is '0' (SEQ), '1' (VIT).
p33 = n, where 'n' is '0' (INT), '1' (REF), '2' (EXT), or 6
(DATA).
p34 = nnnnn.n, external reference frequency in kHz.
A–34
Revision 1
MN/SDM300L3.IOM
Advertisement
Table of Contents
