Table of Contents
Advertisement
SDM-300L3 Satellite Modem
Front Panel Operation
FUNCTION SELECT: UTILITY: INTERFACE:
FRAMING STRUCTURE: INTERFACE: FRAMING STRUCTURE:
T1 FRAMING
Upon entry, the framing type (T1 or E1) is displayed on Line 1. The framing structure of
each type (None or G.704) is displayed on Line 2.
Press [←] or [→] and [↑] or [↓] to select framing structure and type.
Press <ENTER> to execute the change.
FUNCTION SELECT: UTILITY: INTERFACE:
FRAMING STRUCTURE: E1 FRAMING
Upon entry, the framing type (T1 or E1) is displayed on Line 1. The framing structure of
each type (None or G.704) is displayed on Line 2.
Press [←] or [→] and [↑] or [↓] to select framing structure and type.
Press <ENTER> to execute the change.
FUNCTION SELECT:UTILITY: INTERFACE: RTS TX-IF CNTRL
Programs the modem to allow a Request To Send (RTS) signal to enable or disable the
output carrier when data is ready for transmission.
T1 FRAMING
STRUCTURE:
E1 FRAMING
STRUCTURE:
RTS TX-IF CNTRL
OFF
4–103
G.704
G.704
Revision 1
MN/SDM300L3.IOM
Advertisement
Table of Contents
