16-2
WS5100 Series Switch CLI Reference Guide
Command
terminal
16.1.1 clrscr
MAC Extended ACL Config Commands
Clears the display screens
Syntax
clrscr
Parameters
None
Example
WS5100(config-ext-macl)#clrscr
WS5100(config-ext-macl)#
16.1.2 deny
MAC Extended ACL Config Commands
Specifies packets to reject
Syntax
{deny}{any|host source MAC address|source MAC/source MAC address
mask} {any|host destination MAC address|destination MAC/destination
MAC address mask}[vlan vlan-id] [dot1p dot1p-value] [type
value|ip|ipv6|arp|vlan|wisp | 0-65535] [log] [rule-precedence
access-list-entry precedence]
Table 16.1 MAC Extended ACL Config Command Summary (Continued)
Sets terminal line parameters
NOTE: Use a decimal value representation of ethertypes to implement
a
permit/deny/mark
Extended MAC ACLs provide the hexadecimal values for each listed
ethertype. The switch supports all ethertypes. Use the decimal
equvilant of the ethertype listed or for any other type of ethertype.
Description
designation for a packet. The command set for
Ref.
page 16-14