Motorola WS5100 Series Cli Reference Manual page 445

Parameters
low <0-100>
high <0-100>
Example
WS5100(config-wireless)#multicast-throttle-watermarks low 10 high
20
WS5100(config-wireless)#
20.1.27 no
Wireless Configuration Commands
Negates a command or sets its defaults. All the parameters mentioned in the syntax can
be negated using this command
Syntax
no(adopt-unconf-radio|adoption-pref-id|ap-detection|broadcast-tx-
speed|country-code|dhcp-sniff-state|dot11-shared-key-auth|fix-
windows-dhcp|ids|mac-auth-local|manual-wlan-mapping|mobile-
unit|mobility|oversized-frames|proxy-arp|qos-mapping|radio|self-
heal|sensor|service|smart-scan-channels|wlan)
Parameters
Refer to Table 20.1 on page -1
Example
WS5100(config-wireless)#no mobility enable
WS5100(config-wireless)#
Sets the low water-mark. If the percentage of free packets
in the system is lower than this threshold, the incoming
frame is dropped
Sets the high water-mark. If the percentage of free packets
in the system is between the low water-mark and this
value, the packet is subjected to a random-early-drop. If
free packets are greater than this value, the packet is
processed
for the parameters negated using the
Wireless Instance 20-27
command.
no