Motorola WS5100 Series Cli Reference Manual page 76

2-36 WS5100 Series Switch CLI Reference Guide
interface
name-server
route
routing
ssh
telnet
Usage Guidelines
1. The interface and VLAN status is displayed as UP regardless of a disconnection. In
such a case, shutdown the VLAN. Follow the steps below:
a. Check the status of an interface and VLAN using:
WS5100(config)#show ip interface brief
Interface
vlan1
vlan3
WS5100(config)#
b. If the stauts of the VLAN is UP (even if eth1/eth2 is diconnected), shutdown the
VLAN associated with eth1 using:
WS5100(config-if)#show ip interface vlan 3 brief
Interface
Use the show ip interface command to display the
administrative and operational status of all Layer-3
interfaces or a specified Layer-3 interface
• IF NAME – Interface name.
• brief – Brief summary of the IP status and its
configuration
• eth – Ethernet interface.
• vlan – VLAN Interface
Displays static and dynamic name-server entries
Display IP routing table entries
• A.B.C.D – Network in the IP routing table
• A.B.C.D/M – Number of valid bits in the network prefix
IP prefix <network>/<length>, e.g., 35.0.0.0/8
• detail – IP routing table in detail
IP routing status
Secured Shell (SSH) server
Telnet server
IP-Address
157.235.208.69(DHCP)
unassigned
IP-Address
Status
up
up
Status
Protocol
up
up
Protocol