Motorola WS5100 Series Cli Reference Manual page 327

Usage Guidelines
Use this command to permit traffic between networks/hosts based on the protocol type
selected in the access list configuration. The following protocols are supported:
• ip
• icmp
• tcp
• udp
The last ACE in the access list is an implicit deny statement.
Whenever the interface receives the packet, its content is checked against all the ACEs in
the ACL. It is allowed based on the ACL configuration.
• Filtering on TCP/UDP allows the user to specify port numbers as filtering criteria
• Select ICMP to allow/deny packets. Selecting ICMP allows to filter ICMP packets
based on type and code
NOTE: The log option is functional only for router ACL's. The log option
displays an informational logging message about the packet matching
the entry sent to the console.
Example
The example below allows IP traffic from the source subnet to the destination subnet and
denies all other traffic over an interface:
WS5100(config-ext-nacl)#permit ip 192.168.1.10/24 192.168.2.0/24
rule-precedence 40
WS5100(config-ext-nacl)#
The example below permits Telnet traffic from the source subnet and the destination
subnet and denies all other traffic over an interface:
WS5100(config-ext-nacl)#permit tcp 192.168.4.0/24 192.168.5.0/24 eq
23 rule-pre
cedence 10
WS5100(config-ext-nacl)#
The example below permits ICMP traffic and denies all other traffic over an interface:
WS5100(config-ext-nacl)#permit icmp any any rule-precedence 30
WS5100(config-ext-nacl)#)#
Extended ACL Instance 14-17