Mark - Motorola WS5100 Series Cli Reference Manual

16-6 WS5100 Series Switch CLI Reference Guide
Example
WS5100(config-ext-macl)#help
CLI provides advanced help feature.
anytime at the command line please press '?'.
If nothing matches, the help list will be empty and you must backup
until entering a '?' shows the available options.
Two styles of help are provided:
1. Full help is available when you are ready to enter a
command argument (e.g. 'show ?') and describes each possible
argument.
2. Partial help is provided when an abbreviated argument is entered
and you want to know what arguments match the input
(e.g. 'show ve?'.)
WS5100(config-ext-macl)#

16.1.6 mark

MAC Extended ACL Config Commands
Specifies the packet to mark
Syntax
{mark {dot1p <0-7>|tos <0-255>}}
{any|host source MAC address|source MAC source/MAC address mask}
{any|host destination MAC address|destination MAC/ destination MAC
address mask} [vlan vlan-id] [dot1p dot1p-value] [type
value|ip|ipv6|arp|vlan| wisp|0-65535] [log] [rule-precedence
access-list-entry precedence]
Parameters
8021p<0-7>
tos<0-255>
NOTE: Use a decimal value representation of ethertypes to implement
permit/deny/mark designations for a packet. An Extended MAC ACL
provides the hexadecimal values for each listed ethertype. The switch
supports all ethertypes. Use the decimal equvilant of the ethertype
listed in the CLI or any other type of ethertype.
When you need help,
Modifies the 802.1p VLAN user priority
Modifies the TOS bits in an IP header