Permit - Motorola WS5100 Series Cli Reference Manual

16.1.8 permit

MAC Extended ACL Config Commands
Specifies packets to forward
Syntax
{permit} {any|host source MAC address|source MAC\source MAC address
mask} {any|host destination MAC address | destination
MAC\destination MAC address mask} [vlan vlan-id] [dot1p dot1p-
value] [type value|ip|ipv6|arp| vlan|wisp|0-65535] [log] [rule-
precedence access-list-entry precedence]
Parameters
Source MAC Address
Destination MAC Address
dot1p<0-7>
NOTE: Use a decimal value representation of ethertypes to implement
permit/deny/mark designations for a packet. An Extended MAC ACL
provides the hexadecimal values for each listed ethertype. The switch
supports all ethertypes. Use the decimal equvilant of the ethertype
listed in the CLI or any other type of ethertype.
Extended MAC ACL Instance
Specifies the bits to match. The source wildcard
can be any one of the following:
•
xx:xx:xx:xx:xx:xx/
xx:xx:xx:xx:xx:xx
and mask
• any – Uses any source host
• host Defines the exact source MAC
–
address to match
Bit mask specifying the bits to match. The
destination wildcard can be any one of the
following:
•
xx:xx:xx:xx:xx:xx/
xx:xx:xx:xx:xx:xx
address and mask
• any – Uses any available destination host
• host Defines the exact destination MAC
–
address to match
Establishes the 802.1p priority
16-9
–Source MAC address
–Destination MAC