Motorola WS5100 Series Cli Reference Manual page 347

Parameters
Source Mask
Destination Mask
dot1p<0-7>
rule-precedence<1-5000>
type(<1-
65535>|arp|ip|ipv6|vlan|wisp)
vlan<1-4095>
Usage Guidelines
The deny command disallows traffic based on layer 2 (data-link layer) data. The MAC
access list denies traffic from a particular source MAC address or any MAC address. It can
also disallow traffic from a list of MAC addresses based on the source mask
The MAC access list can disallow traffic based on the VLAN and ethertype
Extended MAC ACL Instance
Define a source mask specifying the bits to match.
The source wildcard can be any one of the
following:
•
xx:xx:xx:xx:xx:xx/
xx:xx:xx:xx:xx:xx
and mask
• any – Any source host
• host Exact source MAC address to match
–
Define a destination mask specifying the bits to
match. The destination wildcard can be any one of
the following:
•
xx:xx:xx:xx:xx:xx/
xx:xx:xx:xx:xx:xx
address and mask
• any – Any destination host
• host Exact destination MAC address to
–
match
Determine a 802.1p priority value to match
Define an access-list entry precedence
Set an ethertype value represented as an integer.
Use keywords for well-known ethertypes (IP, IPv6,
ARP etc.)
Set a VLAN tag ID to match
16-3
–Source MAC address
–Destination MAC