D Programming In Memory Mode - Icom IC-7000 Instruction Manual

D Programming in memory mode

[PBT/M-ch/RIT] switch/[M-ch] (inner) control
[PBT/M-ch/RIT] indicator
[MENU/GRP] [F-2]
q Push [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
w Select the menu M-2.
e Push [F-4 V/M] to select memory mode, then se-
lect the desired memory channel with [M-ch].
• Memory channel contents appear instead of the VFO's
frequency readout.
r Set the desired frequency and operating mode.
• To program a blank channel, push [Y(
[Z( )] to select the desired band or use direct fre-
BAND
quency entry with the keypad (HM-151).
t Push [F-2 MW] for 1 sec. to program the displayed
frequency and operating mode into the memory
channel.
[Y]
[Z]
[F-4]
)] or
BAND
MEMORY OPERATION
[EXAMPLE]: Programming 21.280 MHz/USB into
ch 18.
8
8
MW
Push for
1 sec.
104