Memory Programming; D Programming In Vfo Mode; D Programming In Memory Mode - Icom IC-7200 Instruction Manual

■ Memory programming

Memory channel programming can be performed
either in VFO mode or in memory mode.

D Programming in VFO mode

q Push V/M to select VFO mode.
➔
w Rotate [DIAL], and push
sired frequency and operating mode.
e Rotate [M-CH] to select the desired memory
channel.
• If the RIT control indicator lights orange, push
M-CH/RIT
. (p. 61)
SET
• " " appears if the selected memory channel is a
blank channel (one without any stored frequencies).
Channel decreases
r Push and hold
MW
displayed frequency and operating mode into the
selected memory channel.
• 3 beeps are emitted when memory programming is
successful.

D Programming in memory mode

q Push V/M to select memory mode.
➔
w Rotate [M-CH] to select the desired memory
channel.
• If the RIT control indicator lights orange, push
M-CH/RIT
. (p. 61)
SET
• Memory channel contents appear in the display.
Channel decreases
e Rotate [DIAL], and push
sired frequency and operating mode.
• To program a blank channel, use direct frequency
entry with the keypad. (p. 25)
r Push and hold
MW
displayed frequency and operating mode into the
memory channel.
• 3 beeps are emitted when memory programming is
successful.
to set the de-
MODE
RIT control indicator
goes out
Channel increases
for 1 sec. to program the
RIT control indicator
goes out
Channel increases
to set the de-
MODE
for 1 sec. to program the
MEMORY OPERATION
[EXAMPLE]: Programming 7.088 MHz/LSB
into ch 12.
VFO mode
7.088 MHz/LSB are programmed into ch 12.
[EXAMPLE]: Programming 21.280 MHz/USB
into ch 18.
Memory mode
21.280 MHz/USB
are programmed into ch 18.
7
Push
1
Rotate [DIAL]
2
Push
3
4
Rotate [M-CH]
5
6
Push and hold
7
8
9
10
11
12
Push
13
14
Rotate [M-CH]
15
16
17
Rotate [DIAL]
Push
18
19
Push and hold
20
21
62