F-1]; F-2]; Mic Up/Down Speed; Quick Rit/∂Tx Clear - Icom IC-7000 Instruction Manual

13
SET MODE
■ Miscellaneous (others) set mode
30 HM-151 [F-1]
This item programmes for one of several functions to
[F-1] key of HM-151. Programmable key assignments
are described as below.
"P.AMP/ATT" (Preamplifier/attenuator),
"NB" (Noise blanker),
"NR" (Noise reduction),
"MNF" (Manual notch filter),
"ANF" (Auto notch filter),
"TS" (Tuning step),
"SPL" (Split operation),
"A/B" (VCO A/B selection),
"MCL" (Memory clear),
"BNK" (Bank selection),
"COM" (Speech compressor),
31 HM-151 [F-2]
This item programmes for one of several functions to
[F-2] key of HM-151. Programmable key assignments
are same as above.

32 MIC Up/Down Speed

This item sets the rate at which frequencies are
scanned when the microphone (HM-151) [Y]/[Z]
keys are pushed and held. High or low can be se-
lected.
33 Quick RIT/∂TX Clear
This item selects the RIT/∂TX frequency clearing in-
struction with [F-3 CLR] key.
See pgs. 75, 88 for deatails.

34 SSB/CW Synchronous Tuning

This item selects the displayed frequency shift func-
tion from ON and OFF.
When this function is activate, the receiving signal
can be kept to receive even when the operating mode
is changed between SSB and CW.
The frequency shifting value may differ according
to the CW pitch setting.
135
(continued)
MPW
Memo pad write is pro-
grammed. (default)
"AGC" (AGC selection),
"TBW" (TX filter width),
"DUP" (Duplexer),
"TON" (FM tone operation),
"MET" (Meter selection),
"VSC" (Voice squelch control),
"MPW" (Memo pad write),
"MPR" (Memo pad read),
"<SCOPE>" (Scope selection),
"<METER>" (Multi-meter selection)
MPR
Memo pad read is pro-
grammed. (default)
HIGH
High speed (default,
50 tuning steps/sec.)
ON
Clears the RIT/∂TX fre-
quency when [F-3 CLR] is
pushed momentarily.
ON
The displayed frequency
shifts when the operating
mode is changed between
SSB and CW.
ANF
Auto notch filter is pro-
grammed.
NB
Noise blanker function is
programmed.
LOW
Low speed
(25 tuning steps/sec.)
OFF
Clears the RIT/∂TX fre-
quency when [F-3 CLR] is
pushed and held for 1 sec.
(default)
OFF
The displayed frequency
does not shift.
(default)