D Center Mode; D Scope Set Mode - Icom IC-7000 Instruction Manual

5
FUNCTIONS FOR RECEIVE

D Center mode

Displays signals around the displayed frequency
within the selected span. The set frequency is always
displayed at the center of the screen.
q Set a mode and frequency.
w Select G-1 (Scope).
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group G (Graphic).
• Push [MENU/GRP] momentarily one or more times to
select the menu G-1 (Scope).
e Push [F-3 FIX] momentarily to select the center
mode.
• "= " appears when the center mode is selected.
r Push [F-4 SPD] momentarily to select the sweep
speed.
• "≈" or "≈≈" appears when Slow speed or Fast speed is
selected, respectively.
t Push [F-1 SPN] one or more times to select the
desired steps.
• ±10, 25, 50, 100 and 250 kHz are available.
• Push and hold [F-1 SPN] for 1 sec. to select the ±10
kHz step.
• The simple band scope operates in the peak level hold
mode. Peak levels are displayed in the background of
the current spectrum in a different color until the receive
frequency changes. This can be cleared by pushing
and holding [F-2 HLD] for 1 sec., or deactivated in the
scope set mode. (below)
y Push [F-2 HLD] to freeze the current spectrum dis-
play and range.
• "H " and readout frequency indicator appear while the
function is in use.

D Scope set mode

This set mode is used to set the peak hold function
and scope size setting.
q Select G-1 (Scope).
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group G (Graphic).
• Push [MENU/GRP] momentarily one or more times to
select the menu G-1 (Scope).
w Push and hold [F-4 SPD] for 1 sec. to enter the
scope set mode.
e Push [F-1 ≤] or [F-2 ≥] to select the desired set
item.
r Set the desired condition using [DIAL].
• Push [F-4 DEF] for 1 sec. to select a default condition.
t Push [Z(
/
MENU GRP
73
)] to exit from set mode.
[F-1]
[MENU/GRP] [F-2] [F-3] [F-4]
NOTE: If there is a lot of signal noise, turn the pre-
amp OFF and the attenuator ON (p. 74) to reduce
the input level and improve the readability of the
scope.
[MENU/GRP] [F-1] [F-2] [F-4] [DIAL]