One Touch Repeater; Auto Repeater; Tuner (Auto Start) - Icom IC-7000 Instruction Manual

■ Miscellaneous (others) set mode
13 DUP Offset 144M
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for an 144 MHz band only.
The offset frequency can be set from 0.000 MHz to
+9.999 MHz in 1 kHz steps.
14 DUP Offset 430M
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for the 430 MHz band.
The offset frequency can be set from 0.000 MHz to
+9.999 MHz in 1 kHz steps.

15 One Touch Repeater

This item turns the one touch repeater function ON
(DUP-, DUP+) and OFF.
When [F-2 DUP] (M-3) is pushed and held for 1 sec.,
the selected offset direction and programmed duplex
offset frequency (depending on the operating fre-
quency band) is set with the displayed frequency.

16 Auto Repeater

This item turns the auto repeater function ON-1 (auto
duplex setting), ON-2 (auto duplex setting and acti-
vating tone encoder) or OFF.
See p. 65 for details concerning the auto repeater
function.

17 Tuner (Auto Start)

The optional AT-180
ANTENNA TUNER
start capability which starts tuning if the SWR is
higher than 1.5–3:1.
When "OFF" is selected, the tuner remains OFF even
when the SWR is poor (1.5–3:1). When "ON" is se-
lected, automatic tune starts even when the tuner is
turned OFF.
(continued)
DUP-
Minus offset direction is se-
lected. (default)
ON-1
Auto duplex setting is ON.
(default)
has an automatic
ON
Automatic tune function is
ON.
Even when "ON" is selected, automatic tune does
not start for the 50 MHz band.
SET MODE
0.600MHz
0.6 MHz offset (default)
5.000MHz
5 MHz offset (default)
OFF
One touch repeater function
is OFF.
OFF
Auto repeater function is
OFF.
OFF
Automatic tune function is
OFF. (default)
13
13
132