Printronix L1024 Maintenance Manual page 83

3. Remove the Right Inside Cover by removing 1 Screw, then pressing down on the Warning
Label at the front of the Cover. This releases the Locking Tab from the Right Side Cover. See
Detail 6–5 .
NOTE:
4. Open the Printer Front Cover, then remove the LCD Control Panel by removing 2 Screws.
See Figure 6–1 .
5. Remove the Right Side Cover by removing 3 Screws. See Figure 6–1 on page 6–13 .
6. Remove 2 Screws from the Ozone Filter Case and remove it from the Printer. See Figure 6–1
on page 6–13 .
7. Remove the Display Mounting Bracket by removing 2 Screws. See Figure 6–3 .
NOTE:
8. Loosen, but do not remove, 2 Screws on the top of the Stepper Motor Board Frame. Remove
the Frame Cover, and disconnect the Gear Assembly Stepper Motor Cable from the Motor.
See Figure 6–3 .
NOTE:
9. Remove 3 Screws from the Stepper Motor Board Frame (an 8 mm Screw holds the Board
Frame to the Right Side Frame), but do not remove any additional cables from the Frame.
This will allow the Frame to be moved in order to remove the Gear Assembly from the printer.
See Figure 6–3 .
10. Remove 4 Screws from the Gear Assembly Frame (a 10 mm Screw holds the Gear Assembly
Frame to the Right Side Frame), then remove the Gear Assembly Frame from the printer. The
Stepper Motor Board Frame must be moved in order to free the Gear Assembly from behind
it. See Figure 6–3 .
Chapter 6 – Paper Feed Subsystem
Upon installation, the groove on the bottom of the Right Side Cover must
straddle the top edge of the right side of the Tractor Frame. See Detail 6–2
in Figure 6–1 on page 6–13 .
The Cable Grounding Screw does not need to be removed.
The Frame cannot be removed from the printer until the Fuser Base has
been removed.
6–19