Printronix L1024 Maintenance Manual page 151

3. Remove 2 Screws from the rear of the Base Frame, then lift the LVPS to clear the Base
Frame. Push the Power Switch to the OFF position, then slide the LVPS toward the rear of
the printer. Use care to avoid damaging the Power Switch. Once the Power Switch is partially
past the Frame, switch it to the ON position and slide the LVPS free of the Base Frame. S ee
Figure 8–10 .
CAUTION:
NOTE:
Chapter 8 – Power Supplies
Use care to avoid damaging the Fuser Lamp Connector. Ensure that it
does not catch on the Base Plate. When reinstalling the Lamp, be
sure that you route the Fuser Lamp Connector through the Base Plate
before you install the LVPS into the Base Frame. See Figure 8–11 .
When installing the LVPS, ensure that the bottom front of the supply is
locked under the locking tabs on the base frame. See Figure 8–12 .
8–19