Printronix L1024 Maintenance Manual page 242

9. Loosen, but do not remove, 2 Screws on the top of the Stepper Motor Board Frame. Remove
the Frame Cover, and disconnect the Gear Assembly Stepper Motor Cable from the Motor.
See Figure 12–7 .
10. Remove 4 Screws from the Gear Assembly Frame then remove it from the printer. The
Stepper Motor Board Frame will need to be moved in order to free the Gear Assembly from
behind it. See Figure 12–7 .
11. Remove the Front Plastic Paper Guide of the Transfer Charger Assembly by pressing down
on its ends and sliding it to the left. This disengages the Locking Tabs and the Guide can be
easily removed. See Figure 12–8 .
12–22 Chapter 12 – Covers, Frame, and Backplane Board