Printronix L1024 Maintenance Manual page 17

Cleaning Frequency
Area
Fuser When replacing Felt
Heat Roller; Wipers and when
Transfer replacing Developer
Corona Wire; Unit
Charge
Corona Wire
Inside 30,000 pages
Cleaning
LSU 300,000 pages
Cover Glass
Chapter 1 – Introduction
Cleaning
Tool Method
Refer to the Setup Guide.
Refer to the
Setup Guide.
Wet Wipe Remove paper powder and toner from the
Tissue areas listed below:
Transfer Charger around the mylar sheet
(wipe the mylar first, then use the brush
for the wire)
Around the Tractor
Inside the right cover
High Voltage Power Supply cover
Fuser paper guide
Transfer paper guide
Paper guide inlet
Front paper guide (if installed)
Cotton Swab Wipe the LSU Cover Glass with a cotton
and Rubbing swab containing anhydrous rubbing alcohol.
Alcohol Rub the glass in one direction only (either
from right-to-left or from left-to-right).
Repeat this process, using a new cotton
swab each time, until the glass is
completely clean.
1–7