Printronix L1024 Maintenance Manual page 342

Continuous form laser printer

Hide thumbs Also See for L1024:

Table of Contents

1. To replace the paddle drive motor assembly, reverse steps 1 through 4, being sure the keyed

side of the motor shaft faces the paddle drive pulley's set screw.

2. Be sure to tighten the pulley set screw against the flat side of the motor shaft.

Figure C–11. Paddle Drive Motor Removal

The gap distance between the pulley and the paddle drive frame should be

set to approximately 5/32" (4mm).

Appendix C – Continuous Form Stacker

Chapters

Table of Contents

Do you have a question about the L1024 and is the answer not in the manual?