Intermec EasyCoder 501 XP Installation & Operation Manual page 11

Chapter 2 Print a Label
Introduction,
cont'd.
10
Setup
By default, the printer is set up for the following communication
protocol:
Baudrate:
Character length:
Parity:
Stop bits:
Flowcontrol:
New line:
If you want to change any of these values, please refer to chapter
8 "Setup Mode".
Set up the terminal or host computer for the same communication
protocol as the printer.
Paper Supply
Load the printer with labels with a width of at least 35 mm (1.4")
and a length of at least 40 mm (1.6"), and a thermal transfer ribbon,
see chapters 5 and 6.
If the printout becomes too light or dark, you will need to change the
paper type setup, see chapter 8 "Setup Mode".
Startup and Communications Check
Turn on the printer. Provided the printer is not fitted with any
custom-made startup program, after initialization the display will
show the Intermec Shell countdown menu:
ENTER=SHELL
5 sec. v.4.4
4 sec.
3 sec.
2 sec.
1 sec.
Do not take any action. By default, the display window will show the
following message when the countdown is completed, e.g.:
Fingerprint
7.31
If the display does not show this message, refer to chapter 9
"Intermec Shell Startup Program" and select the "Fingerprint"
application.
Intermec EasyCoder 501 XP – Installation & Operation Ed. 4
9600
8
none
1
none
CR/LF
v.4.4
v.4.4
v.4.4
v.4.4