Using Terminal Setup - Intermec EasyCoder 501 XP Installation & Operation Manual

Terminal Setup, cont'd.

Using Terminal Setup

Intermec EasyCoder 501 XP – Installation & Operation Ed. 4
The Terminal Setup program is self-instructing by means of prompts.
You can move around in Intermec Shell in the same manner as
when you control Intermec Shell manually by means of the printer's
display and keyboard.
The Setup part of Terminal Setup follows the same structure as
setup fi les, see later in this chapter. Comprehensive explanations of
the various setup parameters can be found in Chapter 6 "Setting
Up the Printer".
When you transmit the triple T (TTT or ttt) to the printer, the
following message will appear on printer's display:
SETUP FROM
TERMINAL
On the screen of the host, another message will appear:
-----------------------------------------------
Welcome to SHELL v.4.4 in terminal mode
-----------------------------------------------
Answer Y <CR> for Yes, <CR> for No.
----------------
SHELL
SEL. APPLICATION
----------------
(Y / N / B):
From here on, you can move around in Intermec Shell according
to the diagram in the chapter "Using Intermec Shell" by answering
Y (=Yes), N (=No), or B (=Back) to the prompts that successively
appear on the screen.
Note that the program also accepts the corresponding lowercase
characters, i.e. y, n, and b.
Chapter 9 Intermec Shell Startup Program
79