Operation Manual (For Soliton) – VLAN-VPN
H3C S3100 Series Ethernet Switches
Enable the VLAN mapping
function
Note:
A port that is in a link aggregation port group cannot have the VLAN Mapping
feature enabled.
The VLAN mapping function and the protocol-based VLAN function are mutually
exclusive on the same port.
Enabling the VLAN mapping function based on a global VLAN mapping rule for a
port also enables the selective QinQ function on the port.
3.2.3 Enabling the VLAN Mapping Function Based on a Port-level VLAN Mapping
Rule
Table 3-3 Enable the VLAN mapping function based on a port-level VLAN mapping
rule
Operation
Enter system view
Enter Ethernet port
view
Define a VLAN
mapping rule
Operation
Command
system-view
interface interface-type
interface-number
vlan-mapping vlan
old-vlan-id remark
new-vlan-id
Chapter 3 VLAN Mapping Configuration
Command
vlan-mapping
enable
—
—
Required
This command also enables the
VLAN mapping function for the
port.
By default, no VLAN mapping rule
is defined, and the VLAN
mapping function is not enabled
on a port.
3-3
Description
Required
By default, the VLAN
mapping function is
disabled.
Description