Ipv6-Based Vrrp Configuration Examples - H3C S9500 Series Operation Manual

Operation Manual – VRRP
H3C S9500 Series Routing Switches
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
# Display detailed information of the VRRP group on Switch B.
[SwitchB-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Total number of virtual routers: 2
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The above information indicates that in VRRP group 1 Switch A is the master, Switch B
is the backup and hosts with the default gateway of 202.38.160.100/25 accesses the
Internet through Switch A; in VRRP group 2 Switch A is the backup, Switch B is the
master and hosts with the default gateway of 202.38.160.200/25 accesses the Internet
through Switch B.

1.5 IPv6-Based VRRP Configuration Examples

This section provides these configuration examples:
Single VRRP Group Configuration Example
VRRP Interface Tracking Configuration Example
Multiple VRRP Groups Configuration Example
: UP
: 100
: YES
: NONE
: 202.38.160.200
: 202.38.160.131
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 100
: YES
: NONE
: 202.38.160.100
: 202.38.160.1
: Vlan-interface3
: 2
: UP
: 110
: YES
: NONE
: 202.38.160.200
: 0000-5e00-0102
: 202.38.160.131
1-32
Chapter 1 VRRP Configuration
State : Backup
Run Pri : 100
Delay Time : 0
Adver. Timer : 1
State : Backup
Run Pri : 100
Delay Time : 0
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0