Display Ipv6 Route-Table - H3C S3100 Series Command Manual

Command Manual (For Soliton) – IPv6 Management
H3C S3100 Series Ethernet Switches
Description
Use the display ipv6 neighbors count command to display the total number of
neighbor entries satisfying the specified condition.
Examples
# Display the total number of neighbor entries acquired dynamically.
<Sysname> display ipv6 neighbors dynamic count
Total dynamic entry(ies):

1.1.7 display ipv6 route-table

Syntax
display ipv6 route-table [ verbose ]
View
Any view
Parameters
verbose: Displays detailed information about the IPv6 routing table.
Description
Use the display ipv6 route-table command to display brief information about the
routing table, including the destination IP address, prefix length, type of protocol, next
hop, egress interface, and so on. In this case, only the valid route entries are displayed,
Use the display ipv6 route-table verbose command to display detailed information
about the routing table. In this case, both valid routes and invalid routes are displayed.
Examples
# Display summary information about the routing table.
<Sysname> display ipv6 route-table
Routing Table:
Destinations : 4
Destination: ::1/128
NextHop
Interface
Destination: 2008::/64
NextHop
3
Routes : 4
: ::1
: InLoopBack0
: 2008::32
Chapter 1 IPv6 Configuration Commands
1-10
Protocol: Direct
Protocol: Direct