To do...
Configure the maximum number of
equal cost RIPng routes for load
balancing
Displaying and Maintaining RIPng
To do...
Display configuration information
of a RIPng process
Display routes in the RIPng
database
Display the routing information of a
specified RIPng process
Display RIPng interface
information
Reset a RIPng process
Clear statistics of a RIPng process
RIPng Configuration Example
Configure RIPng Basic Functions
Network requirements
As shown in
Figure
from Switch C, which means the route will not be added to the routing table of Switch B, and Switch B
will not forward it to Switch A.
Figure 8-4 Network diagram for RIPng configuration
Configuration procedure
1)
Configure the IPv6 address for each interface (omitted)
2)
Configure basic RIPng functions
Use the command...
maximum load-balancing
number
Use the command...
display ripng [ process-id ]
display ripng process-id
database
display ripng process-id route
display ripng process-id
interface [ interface-type
interface-number ]
reset ripng process-id process
reset ripng process-id statistics
8-4, all switches run RIPng. Configure Switch B to filter the route (3::/64) learnt
8-10
Remarks
Optional
The number defaults to 8.
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view