Table of Contents
Advertisement
Configuring the switch module
Note
The data in operations of this section is used for illustration only. The actual operation data on site shall prevail.
Logging in to the switch module
Obtaining the related data
Before logging in to the switch module, obtain the related data, as described in
Table 16 Related data
Required Data
Management IP address of the OM
module
User name and password used to
log in to the OM module
Slot for installing the switch module
•
The data marked "default" are configured before factory delivery.
•
The data in the table is for illustration only. The actual data during on-site operations shall prevail.
Login mode
You can log in to the switch module in the following modes:
•
Log in to the switch module through the SYS serial port (Console port) of the switch module. For
details, see "Logging in to the switch module through the SYS serial port (console port)."
•
On the OM CLI, log in to the switch module through redirection over the SOL serial port. For
details, see "Logging in to the SOL serial port through redirection."
Logging in to the switch module through the SYS serial port
(console port)
Prerequisites
•
The switch module has been powered on. For details, see "Powering on the switch module."
•
The PC has been connected to the SYS serial port (Console port) of the switch module. For
details about the position of the SYS serial port (Console port), see
Configuration procedure
1.
Set the login parameters and log in to the CLI of the switch module through the Console port
using the remote login software.
Example
•
Management IP address (default): 192.168.100.100
•
Subnet mask (default): 255.255.255.0
•
User name (default): admin
•
Password (default): Password@_
•
Slot number: 1
Table 17
lists the login parameters.
1
Table
16.
"External
ports."
Advertisement
Table of Contents
