Configuring the switch module
NOTE:
The data in operations of this section is used for illustration only. The actual operation data on site
shall prevail.
Logging in to the switch module
Obtaining the related data
Before logging in to the switch module, obtain the related data, as described in
Table 13 Related data
Required Data
Management IP address of the OM
module
User name and password used to log
in to the OM module
Switch module slot
•
•
Login methods
You can log in to the switch module in either of the following methods:
•
Log in to the switch module through the SYS serial port (Console port) on the switch module.
For more information, see
(console
•
Log in to the switch module from the OM CLI through SOL serial port redirection. For more
information, see
Logging in to the switch module through the SYS serial port
(console port)
Prerequisites
•
Power on the switch module. For more information, see
•
The PC has been connected to the SYS serial port (console port) of the switch module. For
more information about the position of the SYS serial port (console port), see
Configuration procedure
1.
Set the login parameters and log in to the CLI of the switch module through the console port
using the remote login software.
The default settings refer to settings in the factory defaults.
The data in the table is for illustration only. The actual data during on-site operations shall
prevail.
"Logging in to the switch module through the SYS serial port
port)."
"Logging in to the SOL serial port through
Example
•
Management IP address (default): 192.168.100.100
•
Subnet mask (default): 255.255.255.0
•
User name (default): admin
•
Password (default): Password@_
•
Slot number: 1
1
Table
redirection."
"Powering on the switch
"External
13.
module."
ports."