Table of Contents
Advertisement
RF OUT
(IF REQUIRED)
Figure 1-15. MM-wave Source Module Leveling Using a Microwave Amplifier
1. Set up the equipment as shown.
2. Refer to menu map 1.
3. Select Leveling Point Module.
on where the interface connection is made.
All of the ALC data necessary to communicate properly with the
synthesizer is exchanged via the SOURCE MODULE INTERFACE.
Hint
To obtain flatness corrected power refer to "Optimizing Synthesizer
Performance, Creating and Applying the User Flatness Correction
Array," later in this section.
IN
AWPLIFIER
0
R F
OUT
NODULE
Getting Started Advanced 1-29
Advertisement
Chapters
Table of Contents
