HP 8360 User Handbook Manual page 338

*RST state is AUTO.
l
l
Sets and queries the list of correction levels that correspond to each
of the frequencies entered using the LIST:FREQ command. The
attenuator is not allowed to change during the list execution. The
number of parameters can be from 1 to 801.
After *RST, the value is 0.
l
Returns the number of correction points that have been entered into
the list array. After *RST returns a 1.
l LIST:TRIGger:SOURce IMMediatelBUSlEXTernal
LIST:TRIGger:SOURce?
l
Sets and queries the list point-to-point trigger source when in the
automatic list mode. See LIST:MODE and 1NIT:CONT for more details.
*RST state is IMMediate.
l
l
Sets and queries the amplitude marker on/off switch. While [n] may
be used, there is really only a single switch for all the markers.
*RST value is OFF.
l
MARKer[n]:AMPLitude:VALue? [MAXimum|MINimum]
l
Sets and queries the value of the amplitude marker. While [n] may
be used, there is really only a single value for all the markers.
l
Sets all the markers to OFF at once. While [n] may be used, there is
really only a single switch for all the markers.
l
This query returns the difference in frequency between the two
specified marker numbers.
MARKer[n]:FREQuency
l
MARKer[n]:FREQuency? [MAXimum|MINimum]
l
Sets and queries the specified marker frequency (marker number
one is the default if [n] is not specified). The value is interpreted
differently based on the value of the marker mode.
I
HP 8360
User's Handbook