HP 8360 User Handbook Manual page 489

example program
flatness correction, l-97
HP-IB check, l-88
local lockout, l-89
looping and synchronization, l-95
setting up a sweep, l-90
synchronous sweep, l-96
use of queries, l-92
use of save/recall, l-93
example programs, l-86-100
examples, equipment used, l-2
examples, simple program messages, l-72
example, stimulus response program, l-76
extended numeric parameters
discussed in detail, l-83
explained briefly, l-74
extenders
HP-IB, C-9
trigger source defined, l-113
external ALC BNC, L-2, L-4
external ALC connector, C-5
external AM, A-16
external detector calibration, E-5
external detector leveling, L-2
external frequency standard, T-l
external leveling, l-23-29
coupling factor, C-13
detector calibration, E-5
low output, l-26
theory of, A-7
with detectors, couplers, or splitters, l-23-26
with power meters, l-27
with source modules, l-28
external power meter range, P-22
external pulse modulation, P-17
external trigger
frequency list, L-8
external trigger, stepped sweep, S-70
external trigger, sweep mode, S-63
F
factor, coupling, C-13
factory preset, P-9
factory-set interface addresses, 3-7
fan filter, clean, 4-5
fastest sweep-retrace cycle, S-62
fault information, F-l
fault information 1, F-2
fault information 2, F-3
fault menu, F-l
fault status
clear, C-2
feature status, D-6
filter