HP 8360 User Handbook Manual page 484

assign softkey, A-22
attenuator, uncouple, U-l
attenuator uncouple, M-14
attenuator, value set, S-59
auto fill increment, A-22
auto fill number of points, A-23
auto fill start, A-24
auto fill stop, A-25
automatically set sweep time, S-76
automatic sweep time, l-10
automatic trigger, stepped sweep, S-69
auto track, A-26
auto track failed message, 2a-1
auxiliary interface connector, C-6
auxiliary output connector, C-5
B
backdating, 5-l
bandwidth
ALC, A-9, A-10, A-11
AM, A-12, A-13
amplitude modulation, A-12, A-13
beginning frequency
flatness correction, A-24
frequency list, A-24
bits
in general status register model, l-101
summary bit in general status register model, l-102
blank display, B-l
BNC connectors, C-4
Boolean parameters
discussed in detail, l-84
explained briefly, l-75
brackets, angle, l-64
BUS
trigger source defined, l-113
C
cabinet, clean, 4-5
cables
HP-IB, C-8
calibrate sweep span always, S-74
calibrate sweep span once, S-75
calibration
full user, F-19
sweep span, F-16
calibration failed message, 2a-2
calibration, user functions, U-3
center frequency, l-8, C-l
CW coupled, C-14
center frequency marker, C-l
change correction value, C-3