(Cont - HP 8360 User Handbook Manual

CONNECTORS
RF Output Connector
Function Group
Menu Map
Description
Programming Codes
See Also
The synthesizer is equipped with a precision 3.5 mm male
connector (2.4 mm male connector on 40 GHz models). The output
impedance, SWR and other electrical characteristics are listed in
"Specifications". When making connections, carefully align the center
conductor elements, then rotate the knurled barrel while the mating
component remains still. Tighten until firm contact is made.
Take care when working with either of these connectors. If this
connector is mechanically degraded in any way, high frequency losses
occur. Refer to Application Note 326, Connector Cure, for more
information.
SWEEP
7
This hardkey initiates continuous sweep-retrace cycling of the
synthesizer. The sweep is initiated by one of the trigger functions,
while the sweep speed is controlled by the sweep time function. The
green LED located above this key lights when the synthesizer is
performing an list, step, or analog sweep. The LED is off
of the following: retrace, band crossings, phase locking at
frequency of each new sweep and during manual sweeps.
SCPI:
Analyzer:
Manual Sweep, [SINGLE)
"Continuous, Single, and Manual Sweep Operation" in Chapter 1.
"Programming Typical Measurements" in Chapter 1.
during all
the start
HP 8360
User's Handbook