HP 8360 User Handbook Manual page 326

l
Causes the sweep in progress to abort and reset. If INIT: CONT is
ON it immediately restarts the sweep. The pending operation flag
(driving *OPC, *WAI, and *OPC?) undergoes a transition once the
is reset.
sweep
l
l
AM[:DEPThl? [MAXimumlMINimum]
Sets and queries the percentage of AM when the SOURce is
converted to percent by the equation:
Valid ranges of dB are 0 to 40 dB. After "RST, the value is 50%.
l
l
AM:INTernal:FREQuency? [MAXimumIMINimum]
Sets and queries the frequency (in Hz) of the internal AM source.
After *RST, the value is 1 kHz.
AM:INTernal:FUNCtion SINusoidlSqUarelTRIanglelRAMPlNOISe
l
l
AM:INTernal:FUNCtion?
Sets and queries the waveform of the internal AM source. After
AM:SOURce INTernallEXTernal
l
l
AM:SOURce?
Sets and queries the source of the AM modulating signal. After
l AM:MODE DEEPlNORMal
Controls the AM depth limits of the synthesizer. The NORMal
position is selected at *RST.
l
AM:STATe ONlOFFlllO
AM:STATe?
l
Sets and queries the status of the AM modulation. After *RST, the
setting is OFF.
l AM:TYPE LINearlEXPonential
Sets and queries the type of AM modulation. After *RST, the
setting is LINear.
CALibration:AM:AUTO ONlOFFlllO
l
Sets and queries the automatic modulator calibration switch.
HP 8360
User's Handbook