Fm Coupling 1Ookhz - HP 8360 User Handbook Manual

Function Group
Menu Map
Description
Programming Codes
See Also

FM Coupling 1OOkHz

Function Group
Menu Map
Description
HP 8360
User's Handbook
List Menu
"Optimizing Synthesizer Performance" in Chapter 1.
"Programming Typical Measurements" in Chapter 1.
POWER
5
This hardkey applies flatness correction to the synthesizer RF output.
If no array has been created, pressing this key applies 0 dB of flatness
correction at all points. The yellow LED above the hardkey lights
when user flatness correction is on.
SCPI:
CORRection[:STATe] ON]OFF]l]O
Analyzer:
NONE
"Optimizing Synthesizer Performance" in Chapter 1.
4
This softkey (Option 002 only) lets you set the FM input to be
AC-coupled. If you choose AC-coupled FM, you will be modulating a
phase locked carrier. This is the specified synthesized operation. You
must modulate at a 100 kHz rate or greater. If not, the frequency
changes caused by the modulation are inside the phase locked loop
bandwidth and the output will not be linear FM. For modulation
frequencies below 100 kHz, choose DC-coupled FM.
An asterisk next to the key label indicates that AC FM coupling is
selected. This selection is the factory preset default.
For synthesizers without Option 002, see FM &r/Off 100 kHz .
Operating and Programming Reference F-l 1
Coupling 1OOkHz