HP 8360 User Handbook Manual page 344

analogous to those for frequency sweep. Power sweep is allowed to be
negative, unlike frequency sweeps. "RST value is 0 dBm.
PULM:EXTernal:DELay <num>[time suffix] IMAXimumlMINimum
l
PULM:EXTernal:DELay? [MAXimumIMINimum]
l
Sets and queries the value of pulse delay from the time the external
pulse signal arrives to when the video pulse is generated. The
minimum value is 225 ns. After *RST the value is MINimum.
l
PULM:EXTernal:POLarity?
l
Selects the polarity of the external pulse signal. NORMal causes
the positive-going edge of the signalto trigger the internal pulse
generator and to turn on the RF. After *RST the value is NORMal.
PULM:INTernal:FREQuency Cnum>[freq
l
PULM:INTernal:FREQuency? [MAXimumIMINimum
l
The *RST value is 500 kHz.
PULM:INTernal:GATE ONlOFFlllO
l
PULM:INTernal:GATE?
l
Sets and queries the state of the internal pulse generator's gating
control. When ON, and the pulse trigger source is internal, the
external pulse input is used to gate the pulse generator. When pulse
trigger source is external, this switch is ignored and no gating is
possible. After *RST, the setting is 0.
PULM:INTernal:PERiod <num>[time suffix] IMAXimumlMINimum
l
PULM:INTernal:PERiod? (MAXimumlMINimum]
l
Sets and queries the period of the internal pulse generator.
The *RST value is 2 pus.
PULM:INTernal:TRIGger:SOURce INTernallEXTernal
l
PULM:INTernal:TRIGger:SOURce? [MAXimumlMINimum]
l
Sets and queries the setting of the internal pulse generator's trigger
source. When INTernal, pulse period and frequency determine the
repetition rate of the pulse train. When in EXTernal, the repetition
rate is set by the EXT PULSE in jack. After *RST, the value is
PULM:INTernal:WIDTH <num>(time suffix]lMAXimum(MINimum
l
PULM:INTernal:WIDTH? [MAXimumJMINimum]
l
Sets and queries the width of the internal pulse generator. The *RST
value is 1 ps.
HP 8360
User's Handbook