Continuous, Single, And Manual Sweep Operation - HP 8360 User Handbook Manual

Continuous, Single,
and Manual Sweep
Operation
1-12 Getting Started Basic
Continuous sweep is the operation mode set when the synthesizer is
preset. It simply means that when the synthesizer is performing a
swept operation, the sweeps will continuously sweep-retrace-sweep-
retrace until a different sweep mode is selected. To choose this sweep
mode, press (CONT).
To change from continuous sweep to single sweep operation, press
and switch to the single sweep mode. This initial keystroke cause's
the synthesizer to switch sweep modes, but it does not initiate a
single sweep. A second keystroke (press (%jGFJ initiates a single
sweep. When the synthesizer is in single sweep operation, the
amber LED above the key lights. When the synthesizer is actually
performing a sweep in single sweep mode, the green SWEEP LED
lights.
The manual sweep mode lets you use the rotary knob to either sweep
from the start frequency to the stop frequency or to sweep power.
Refer to menu map 8, SYSTEM.
Press (PRESET).
Press SWEEP (j).
Manual Beep.
Select
The active entry area displays:
Use the rotary knob to sweep from the start to the stop frequency.
The green SWEEP LED is off in manual sweep mode because the
sweeps are synthesized.