HP 8360 User Handbook Manual page 479

Inputs & Outputs RF
output
Nominal output inpedance 50 ohms (precision 35 mm male on 20 and 26.5 GHz models,
kohms, damage kvel -c 15 volts. See RF Output sp&ftcations. (I3NC female, tint paneL)
Pulse xnput/output
connector Nominal input impedaxe 50 ohms, damage level +55, -05 volts See
Modulation fspeSca* @NC femak front paneL)
AM Input
Nominal input impedance 50 ohms (internally switchable to 2 kohms), damage level -c 15
volts See Modulation spe&catLons @NC female, front panel.)
Nominal input impedance 50 ohms (internally switchable to 600 ohms), damage level -e 15
volts. See Mod&ion sped&a- @NC female, front panel.)
Activated on a TIL rising edge. Used to externally
to the next point in step or list mode. Damage level +5.5, -0.5 volts. @NC female, rear
Outputs a one-microsearnd-wide lTIAeve1 pulse at 1601 points evenly spaced across an
analog sweep, or at each point in step or list mode. @NC female, rear panel.)
10 MHZ Refmee Input
Accepts 10 MHz* 100 Hz, 0 to + 10 dRm reference signal for operation from external time
10 MHz Reference Output
Nominal signal level 0 d&n, nominal output impedance 50 ohms. @NC female, rear panel)
sweep output
Supplies a voltage prop&onal to the sweep ranging from 0 volts at start of swap to
to percentage of full instrument &equency range. Minimum load impedance 3 kohms.
Sweep will stop when gmunded extemally. TIL-high while svxeping, TIL-low when
Supplies voltage pmpodod to output htzqmcy at 05 volts/GHz (internally switchable
to 0.25 or 1 volt/GHz) Maximum output 18 volts Minimum load impedaw 2 kohms
Nominal input impedance IO0
standard internal pulse &mrator~ a
the
or to advance
initiate an analog swep
User's Handbook
HP 8360