Power Sweep - HP 8360 User Handbook Manual

Power Sweep

Function Group
Menu Map
Description
Programming Codes
See Also
HP 8360
User's Handbook
in dB/Hz, and t is either "DB" or the ASCII LF terminator. For
example, for a slope of 1.5 dB/GHz use this procedure:
1. 1.5 dB/GHz = 1.5 dB/1,000,000,000 Hz
2. 1.5 dB/lES Hz = 1.5E-9 dB/Hz
3. The programming code is "SL11.5E-9 DB"
),
Power Sweep
LEVEL
"Power Sweep and Power Slope Operation" in Chapter 1.
POWER
This softkey enables the power sweep function. RF output power
can be swept both positively and negatively over a selected range.
The level of the power sweep starting point is the power level
programmed. Power sweep widths can be 45 dB wide in either
direction. However, the settable power sweep range is dependent on
the ALC level set. An asterisk next to the key label indicates that
this feature is active.
POWer:MODE SWEeplFIXed
POWer:STARt <num>[level suffix]]MAXimum]MINimum
POWer:SPAN <num>[level suffix]]MAXimum]MINimum
Analyzer:
POWER LEVEL , Power Slope
"Power Sweep and Power Slope Operation" in Chapter 1.
Operating and Programming Reference P-7
Power Sweep