Setting Up A Typical Sweep, Example Program 3 - HP 83751A Programming Manual

Getting Staned Programming
Programming Typical Measurements

Setting Up A Typical Sweep, Example Program 3

frequency range, sweep time, power level, and marker frequencies for a
test measurement. This program sets up the sweeper for a general purpose
situation. The instrument is the same as in program 1. Clear and reset the
controller and type in the following program:
IO
20
30 LOCAL 7
40 CLEAR Source
50 REMOTE Source
60 OUTPUT Source;"*RST"
70 OUTPUT Source;"FREQuency:MODE SWEepI'
80
OUTPUT Source;"FREQuencp:STARt 4 GHZ"
90 OTJTPUT Source;"FREQ:STOP 7 GHz"
100 OUTPUT Source;"POWer:LEVel -5 DBM"
120 OUTPUT Source;": MARKerI:STATe 0N;FREQuency 4.5GHZ"
130 OUTPUT Source;"MARKer2:STATe 0N;FREQuency 6IIIE6"
140 OUTPUT Source;"*OPC?"
150 ENTER Source;X
160 OUTPUT Source;"POWer:STATe ON"
170 OUTPUT Source;"INITiate:CONTinuous ON"
180 CLS
190 PRINT "Source setup complete."
200 PRINT "Verify that the source is sweeping from"
210 PRINT "4 GHz to 7 GHz at a power of -5 dHm,"
220 PRINT "with a sweeptime of 0.5 seconds."
230 END
Run the program.
1-54