Table of Contents
Advertisement
2. Connect the Ethernet cable to the connector at the bottom of the TPC.
3. Replace the bottom cover feeding the cable through the opening.
4. Connect the other end of the Ethernet cable to the laser system network switch.
Set up Mirage 4KLH projectors for 3D
The Mirage projector is capable of displaying stereoscopic 3D video sources, relying on additional
hardware (stereo emitters and glasses) to complete the display system.
Images generated from a stereo 3D video source consist of a series of images (frames) that
alternate quickly between two slightly different viewpoints, corresponding to our left and right eyes.
When these frames are displayed fast enough and viewed with special glasses synchronized to the
left/right (L/R) changes, the resulting image appears with the same depth and perspective sense in
the real world.
The type of 3D glasses can be active or passive stereo depending on the type of stereo
controllers and screen used.
3D requirements
Stereo 3D applications require a stereo 3D-capable source, special hardware and software setups,
and the projector's 3D Settings menu option to control the projector's processing, synchronization,
and displaying of the stereoscopic 3D source material.
Hardware requirements
Note the following hardware requirements for stereo 3D applications:
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Installation
42
Advertisement
Table of Contents
