Connect Devices; Connect A Video Source Via 3G-Sdi - Christie D4K2560 User Manual

Connect Devices

This section provides information and procedures for connecting external devices to the projector.
Communication and input ports are located on the projector side input panel, accessed by removing
the input panel cover. When connecting devices, route all cables along the channels located on the
bottom of the projector and up through the opening in the frame to the communication port.
Input signal devices are connected are connected to the video option cards and communication
devices are connected at the MCPU panel.

Connect a Video Source via 3G-SDI

The 3G Input Card (3GIC) accepts digital video data from HD and 3G-SDI (Serial Digital Interface)
sources. Various input configurations are supported.
Input
Configuration
Four-Port Enables connection of four SDI cables to two 3GIC cards (using the
1-IN and 2-IN inputs of two cards in slots 1 and 2, or in slots 3 and
4). Each SDI input supplies one quadrant of a 4K input image. This
configuration supports high resolution and high frame rate input
video streams, including both 2D and 3D direct inputs.
Four-Port, Dual- May be used for Dual-Input 3D configurations. For information on the
Input 3D video quadrant mapping for the 3GIC four-point input configuration,
see
Single One-Port Enables connection of one SDI cable to the 1-IN input of a 3GIC card
(in any slot). In this configuration the SDI input supplies the entire
video raster.
One-Port, Dual- May be used for Dual-Input 3D configurations.
Input 3D
D4K2560/ Mirage 4K25 User Manual
020-101076-02 Rev. 1 (11-2013)
Description
Four-Port Input Video Quadrant Mappings
Two 3GIC cards
Four 3GIC cards
on page 26.
One 3GIC card
One or two 3GIC cards
Requirements
23