Syslog Setup - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 6 Monitoring Settings
6.2 Various Notification Settings
10
Click the [OK] button.
The e-mail notification settings are applied.
11
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
6.2.3

Syslog Setup

If an event occurs in the ETERNUS DX Disk storage system, logs for the event can be sent to the specified
syslog server (external server).
Up to two syslog servers can be set.
•
Make sure to check whether the syslog server receives logs correctly after the syslog notification environ-
•
ment setup is complete.
Logs are not sent again when a communication error occurs between the ETERNUS DX Disk storage sys-
•
tem and the syslog server.
The syslog setting is explained below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Network].
The [Network] screen appears.
3
In [Action], click [Setup Syslog].
The [Setup Syslog] screen appears.
4
In the [Setup Syslog] screen, set the required items.
Select "on(RFC3164)" or "on(RFC5424)" for "Send Log".
•
To send messages in RFC5424 format to a target syslog server that supports RFC5424, select "on
(RFC5424)". If this is not the case, select "on (RFC3164)".
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
111
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0