High-Density Drive Enclosure Installation (For Regions Other Than Emea&I) - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 2 Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
2.4 High-density Drive Enclosure Installation (for Regions Other
than EMEA&I)
This section describes how to install a high-density drive enclosure in a rack.
High-density drive enclosures must be installed above the controller enclosure. When installing multiple
high-density drive enclosures, install them in the order of the "DE_No. label" numbers that are attached to
the high-density drive enclosures. The DE_No. labels are attached on the following locations.
Right front side of the high-density drive enclosure
1
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Pull the rail lock lever in the direction of the arrow and unlock it to adjust the length of the rack rails to
match the distance between the front and the rear rack pillars. Leave the rail lock lever unlocked be-
cause the rail lock lever is locked after the rack rail is installed.
[Left]
(Rack pillar: front)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
DE_No. label
Rail lock lever
Unlock the levers to adjust the length of the
rack rails to match the distance between the
front and rear rack pillars.
Rack rail (left)
"Left" is on the exterior
[Right]
38
Copyright 2014 FUJITSU LIMITED
Upper right rear side of the high-density drive enclosure
Rack rail (right)
"Right" is on the exterior
(Rack pillar: rear)
P3AM-7652-02ENZ0