Fujitsu ETERNUS DX200 S3 Configuration Manual page 42

Chapter 2 Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
6
Fasten the high-density drive enclosure in the rack.
Use four M5 screws to fasten it in the rack.
M5 screws
(Rack pillar: front)
7
Attach the cable management arm.
To attach the cable management arm, place the arm in the bracket on the rear of the high-density
drive enclosure. After placing the arm in the bracket, firmly attach the arm with the pin.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
M5 screws
Cable
management arm
42
Copyright 2014 FUJITSU LIMITED
(Rack pillar: rear)
Pin
P3AM-7652-02ENZ0