Fujitsu ETERNUS DX200 S3 Configuration Manual page 58

Chapter 4 Connecting Cables
4.2 Drive Enclosure Connection
1
Attach the destination labels to the connectors of the cables between enclosures.
(1)
Before attaching the destination labels, check the connection destination of the cables between
enclosures.
• The connector on which the "n" symbol is printed is connected to the DI (OUT) port on the con-
troller enclosure or the drive enclosure.
The connector on which the "l" symbol is printed is connected to the DI (IN) port on the drive
•
enclosure.
The following figures show the connection of the cable between enclosures connecting the con-
troller enclosure to drive enclosure 1 and connecting drive enclosure 1 to drive enclosure 2.
• When only one controller is installed
Drive enclosure 2
Drive enclosure 1
Controller enclosure
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
58
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0