3.5" Type Drive Enclosure Installation (For Regions Other Than Emea&I) - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 2 Rack Installation
2.3 2.5" / 3.5" Type Drive Enclosure Installation (for Regions Other than EMEA&I)
2.3 2.5" / 3.5" Type Drive Enclosure Installation (for Regions Oth-
er than EMEA&I)
This section explains how to install a 2.5" / 3.5" type drive enclosure in a rack.
Drive enclosures must be installed above the controller enclosure. When installing multiple drive enclo-
sures, install them in the order of the "DE_No. label" numbers that are attached to the drive enclosures.
The DE_No. labels are attached on the following locations.
Right front side of the drive enclosure
1
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front and
rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to the rack
before they can be completely tightened.
Loosen the M4 screws to
adjust the length of the
rack rails to match the
distance between the
front and rear rack pillars.
[Left]
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Upper right rear side of the drive enclosure
DE_No. label
Rack rail (left)
An "L" mark is on the
inner side.
(Rack pillar: front)
[Right]
Copyright 2014 FUJITSU LIMITED
(Rack pillar: rear)
Rack rail (right)
An "R" mark is on the inner side.
35
P3AM-7652-02ENZ0