Fujitsu ETERNUS DX200 S3 Configuration Manual page 67

Chapter 4 Connecting Cables
4.4 Power Cord Connection
Connect the PSU#0 power cord to power distribution unit#0 (the lower power distribution unit).
•
Connect the PSU#1 power cord to power distribution unit#1 (the higher power distribution unit).
For the high-density drive enclosure, connect the PSU#0 and PSU#2 power cords to power distribu-
•
tion unit#0 (the lower power distribution unit). Connect the PSU#1 and PSU#3 power cords to pow-
er distribution unit#1 (the higher power distribution unit).
The following figures show a connection diagram of AC outlet cables.
For outlet ´ 12
•
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Drive enclosure 3
Drive enclosure 2
PSU#2 Inlet
Drive enclosure 1
PSU#0 Inlet
Controller enclosure
PSU#0 Inlet
: Connect OUTPUT#0-n of the power distribution unit to the PSU#0 inlet of the ETERNUS DX Disk storage system.
: Connect OUTPUT#1-n of the Power distribution unit to the PSU#1 inlet of the ETERNUS DX Disk storage system.
Copyright 2014 FUJITSU LIMITED
PSU#3 Inlet
PSU#1 Inlet
PSU#1 Inlet
Power distribution
unit #1
Power distribution
unit #0
67
P3AM-7652-02ENZ0