Chapter 6 Monitoring Settings; Event Notification Setup - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 6
Monitoring Settings
Perform the ETERNUS DX Disk storage system monitoring setup if required.
For details on the settings, refer to "Configuration Guide (Web GUI)".
6.1

Event Notification Setup

Select whether to report events detected in the ETERNUS DX Disk storage system. There are six methods for
event notification: Host Sense Key Code Qualifier, SNMP Trap, E-Mail, syslog, REMCS, and AIS Connect.
The event notification setting is explained below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Event/Dump].
The [Event/Dump] screen appears.
3
In [Action], click [Setup Event Notification].
The [Setting based on Severity] tab screen of the [Setup Event Notification] screen appears.
4
In the [Setting based on Severity] tab screen, select the required items.
5
On the screens that are displayed by clicking each level tab, select the required items.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
101
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0