Fujitsu ETERNUS DX200 S3 Configuration Manual page 122

Chapter 7 Power Control Setup
7.1 Setup of the Auto Power Function and/or the Power Resume Function
Settings for the power control functions
Auto Power function is enabled
Power Resume function is enabled
The procedure to enable the Auto Power function and/or the Power Resume function is described below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [System Settings].
The [System Settings] screen appears.
3
In [Action], click [Setup Power Management].
The [Setup Power Management] screen appears.
4
In the [Setup Power Management] screen, select [Enable] for [Auto Power], [Power Resume], or both.
5
Click the [Set] button.
A confirmation screen appears.
6
Click the [OK] button.
The Auto Power function and/or the Power Resume function setting is applied.
7
Check the setting completion message and click the [Done] button.
The screen display returns to the [System Settings] screen.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
How the ETERNUS DX Disk storage system operates
The ETERNUS DX Disk storage system is automatically
turned on when AC power is supplied and when power
is restored after a power failure.
122
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0