Fujitsu ETERNUS DX200 S3 Configuration Manual page 31
Disk storage system
Hide thumbs
Also See for ETERNUS DX200 S3:
- User manual (1082 pages) ,
- Design manual (207 pages) ,
- Setup manual (129 pages)
Table of Contents
Advertisement
Chapter 2
Rack Installation
2.1
Installing Power Distribution Unit (for Regions Other than EMEA&I)
2
Install the power distribution unit in the rack.
Fasten it to the prepared holes in the pillars with eight M5 screws.
M5 screw
3
Attach the blank panel to the rack front.
The blank panel should be attached at the same height as the power distribution unit.
(Rack pillar: rear)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
M5 screw
Power distribution unit
Copyright 2014 FUJITSU LIMITED
(Rack pillar: rear)
Blank panel
(Rack pillar: front)
31
P3AM-7652-02ENZ0
Advertisement
Table of Contents
